HyLoft 80842-10 Guía de instalación descargar pdf (Pagina 3)

Alternate Installation on to Existing Hyloft Unit

Place the Hyloft Sticker provided on Corner Rod (A) for easy access to contact information.

Make sure that all nuts, bolts and screws are tight. Do not load with more than 200 Ibs, evenly

distributed.

Determine location needed for storage & insert Downrods (A) through grid of existing Hyloft Rack at an angle. Straighten

and pull down Downrods (A) until the top of the Downrod hooks over the grid wires as shown. Continue with step 2 on

previous page to install Corner Rods (B&C) and support Bars (D&E), adjusting height and width as needed.

IMPORTANT: Combined storage weight of both racks must not exceed 200 Ibs.

Page 4 of 12

1 2 3 4 5 6 7 8 ... 12 13

Sin comentarios

HyLoft 80842-10 Guía de instalación Pagina 3